**Quick
Fix and Ace-It are the same synthetic urine drug testing labs use to
check the accuracy of their equipment.**
**NOT intended
for unlawful use. Consult applicable state and local laws in
your area
concerning the
legal use of these products.**
Best
product for DOT Drug screenings
Description:
Quick Fix and
Ace-It synthetic urine are premixed laboratory urine
designed to protect your privacy during a urinary drug test.
The Quick Fix and Ace-It synthetic urine are unisex so a male or female
can use it to pass a drug test. To ensure passing a urine drug test,
the Quick Fix and Ace-It contain all the ingredients
normally found in urine and is balanced for pH, specific
gravity, creatine, and several other urine characteristics. So, there is no need to undergo drug test detox. Quick
Fix and Ace-It synthetic urine are so close to real human urine that it
is completely undetectable by the lab. They
contain two ounces of synthetic urine as required by the
DOT guidelines. If a lab demands more than two ounces, that
demand is operating outside of the DOT guidelines. Request
the lab record the volume of the sample before disposal and
be sure to document the error. The Quick Fix and Ace-It bottle comes
with an attached temperature strip and heating pad to ensure
the sample is at body temperature, making sure it is not fake urine.
If urinalysis is not meant just for the drug test, we recommend the use of a detox drink before you take the test.
Directions
To use,
simply pour contents of container into urine cup
at drug testing facility. Make sure sample is within
proper temperature range of 94?-100?F. The container can be microwaved up to 10 seconds for initial
heat. Be sure to pop up the top prior to heating to release
pressure. After heating, close cap and shake bottle. If the
temperature remains out of range after first heating, repeat
procedure. If the temperature is not in range after two
attempts, make sure the container has not been over heated
above the 100?F (let cool a few minutes). The heater pad
without the microwave will require approximately an hour to
warm up to range of 90?-100?F. The heater pad can also be
taped to the bottle for prolonged heat, and will keep the
bottle near 100?F for up to six hours in an inside pocket of
clothing being worn. Some settling may occur. Shake bottle
before and after heating, prior to deadline.
Product
Warnings:
This product is not intended for use on lawfully
administered drug tests and is to be used in accordance with
all federal and state laws. If you are looking for drug kits, please navigate to Home Drug Test
